Ask Experts Questions for FREE Help !
Ask
    tstrazza's Avatar
    tstrazza Posts: 1, Reputation: 1
    New Member
     
    #1

    May 25, 2009, 11:14 AM
    Ceiling Fan installation
    I am installing a Hampton Bay Ceiling Fan with light kit. When I removed the old fixture, I noticed I had the green ground wire, the white neutral wire, and a red and black wire. The Red wire was used on the old fixture, and the black wire was capped. When attacing the new fixture I used the red wire as the hot wire and the unit is not working. Should I try the black wire? I am open to suggestions. Thanks for everyone's help with this, It is HOT in NJ. I need the fan NOW! LOL
    jerro's Avatar
    jerro Posts: 172, Reputation: 5
    Junior Member
     
    #2

    May 25, 2009, 12:27 PM

    Wire white to white, green to ground green, black and blue wire(for the light) connected to the red wire. Leave black wire capped.Should have pull chain on fan to control fan speed. Turn power on and pull the chain.Also has a forward and reverse switch on fan, make sure it is not stuck in the middle.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #3

    May 25, 2009, 12:47 PM
    Agree with Jerro. The red worked before it should work now.
    Not to sound too obvious, but did you check the wall switch?
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
     
    #4

    May 27, 2009, 06:15 PM

    Check the reverse switch as well as the pullchain.

    General ceiling fan troubleshooting and help FAQ- Ceiling Fans N More

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ceiling Fan Installation [ 15 Answers ]

Hi: I just bought a Hampton Bay Ceiling fan with remore model # 507 386 UPC # 082392726089 from home depot. I am trying to install the receiver, any tips? I have tried putting it into the mounting plate and I can not get it to fit. Any help would be greatly appreciated.

Ceiling fan installation [ 8 Answers ]

I trying to install a ceiling fan with light combo. The house is "prewired" (5 yrs old). Under the cover/cap ceiling, there are 1 black, 1 white, 1 green, 1 pink. Followed instruction booklet I connect as follow: Fan black and blue to ceiling black Fan white to ceiling white Fan green to...

Ceiling Fan Installation [ 1 Answers ]

I have a Hampton Bay fan to be installed on a 6' droprod to a slanted ceiling I need a canopy large enough to hold the remote receiver and able to let the 3/4 inch droprod swivel through the hole

Ceiling Fan Installation [ 4 Answers ]

I have a very steep family room ceiling angle. I proceeded to install the fan and found out that the drop down bar does is not level due to the ceiling angle. Is there a special installation kit (hangar unit) for steeply angled ceilings? Barry

Ceiling fan installation [ 3 Answers ]

? I have a used ceiling fan with lights and have no idea on how to wire it. I have 3 wires comeing out of the ceiling. Black, white and bare copper. The fan/light assembly has 3 wires black, blue and white. The mounting bracket has 1 green wire and the part the post part has a green wire on it...


View more questions Search