 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Compressor fan Motor?
My compressor stopped and needed to be reset. I pushed the reset button on the outside of the unit and the compressor came on but the fan did not.I am assuming without the fan motor it overheated and needed to be reset. I pushed the fan blade with a screw driver to spin the motor and it came on. Later the thermostat turned off the air conditioning unit and the compressor did the same thing. Compressor came on but no compressor fan. I have not yet tried to nudge the fan blade again to kick start it. Can anyone tell me what they think this might be? Is it the fan motor or should I look at some electrical components first.I have some basic knowledge of air conditioning mechanics. Please help.
|
||||
|
||||
|
It is not uncommon for AC fan motors to wear out and seize up. You can replace the fan motor. But try this. With the power off, rotate the fan by hand. Does it turn hard? It should rotate freely -- even spinning freely when you let go of it. If it doesn't turn feely, the bearing has seized and the motor needs to be replaced. If it's wobbly, it also needs to be replaced. I'd also suggest replacing the starting capacitor at the same time.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a 230 volt 15 amp 60 hz 1 ph air compressor motor I want to wire. I am little confused when I open the switch there is 1 black, 1 white and one ground. I am to assume that the white is to be hot to be 230 volts. I'm running 14/3 through out my walls with a 20 amp dual pole breaker. So in...
My a/c compressor motor will not start when I turn on down the thermastat unless I go outside and manually spin it to get it started. It will run for about 15 minutes and then it will stop again. I have to turn the air off for about 30 minutes and then I can turn it on and manually start it again...
Tried to connect my air compressor up and the breaker will not stay on. Other ansers make me believe this is a short, however, the wiring had no problems before and the motor is new. The breaker is a 30 amp, the motor only needs a 25.
The compressor motor stopped running,(I was told it was bad) so I replaced it. When I started the unit back up it ran for a few minutes, but when the compressor tried to kick in it shuts off. I tried it several times but whenever the compressor tries to kick in it keeps shutting off. They gave me a...
With the AC on and running the temperature started to rise in the house. I put my hand next to the register. Air was blowing but was not cool air. I went outside and the compressor fan motor wasn't blowing. On another occasion the same thing happened and I went outside and the fan motor was making...
View more questions Search
|
