Ask Experts Questions for FREE Help !
Ask
    BriansDryer's Avatar
    BriansDryer Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 8, 2009, 05:36 AM
    Whirlpool Dryer
    I can not find my manual for my whirlpool dryer and I need to replace the coil packs. I just need to know how to get to them, through the front or back of dryer. Can you remove the front of the dryer without the drum falling?
    Perito's Avatar
    Perito Posts: 3,139, Reputation: 150
    Ultra Member
    		  
    #2

    May 8, 2009, 05:47 AM

    In most of the dryers that I've worked on (not a huge number), the drum actually rests on the front wall of the dryer. When you remove the front, the drum falls out. This is by design so you shouldn't worry about it. It's fairly simple to get it back in place -- simply rest if on the back "bearing". Reach through the dryer door and support the drum while replacing the front. You may or may not need someone to help you -- I've always manged to do it alone.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool dryer [ 3 Answers ]

My dryer recently stopped heating ,my gas was turned off recently ,does that effect my heating elemant?And also it did pop the breaker for the dryer... :rolleyes: :rolleyes:

Whirlpool dryer gets too hot [ 1 Answers ]

My whirlpool dryer is a Roper model. I am having problems with it shutting off in the middle of the cycle. It is like it is getting to hot, because if I put a small load in it at night when it is cool then it runs fine. Now the problem is that it is smoking. We have already cleaned all the lint...

Whirlpool Dryer [ 1 Answers ]

I have a whirlpool stackable dryer model # LEW0050PQ3. It runs but doesn't heat up. Only cool air comes out. Its only 8 months old! I was told there is a reset button somewhere on the back but I cannot seem to locate it. Is this true?

Whirlpool dryer [ 1 Answers ]

I have a whirlpool dryer and it want start... I turned my timer on and press the start button and want do anything.. but you can hear a noise at the timer button and when youn go to press the start button the noise stops... I am wondering if its the timer button or the start button?

View more questions Search