Ask Experts Questions for FREE Help !
Ask
    Hari1612's Avatar
    Hari1612 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 26, 2009, 10:51 PM
    Machining of Stainles Steel Stud
    Hi,

    I hv got a drawing from my customer for machining of stainless steel stud D-3" x L-117.46" with a run out of 0.02".

    It also has 5 grooves to machined on its surface and a hexagonal hole (stamping) at one of its end for 0.48".

    Can anybody assist me on what process with machine details to be followed for this ?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Apr 27, 2009, 03:03 AM

    You might purchase shafting PBC Linear - Your Source for Innovative Linear & Rotary Motion Bearings, Systems, Technologies, and Solutions.

    And then do the holes and grooves by EDM.

    The problem with shafting is that it's hardened.

    Maybe you can convince someone to sell it before it's hardened.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Run out in machining big shaft D280 x L 3500 mm [ 7 Answers ]

I want to ask if we can get run out in shaft D280x3500 mm araund 30 micron in cnc machine . While the shaft inside the machine we have the value with in 30 micron but when we take the shaft in CMM room we have different value around 80 micron if any one can help me??

Runout in machining [ 2 Answers ]

what are possible causes/solutions to reduce/eliminate runout in machining a shaft. Part is chucked with a tailcenter and steadyrest. I read previous post of the 30... 80 microns of that shaft. Could someone also define the value of a micron.

Maths related to CADCAM machining geometry [ 1 Answers ]

I am machining sectors ( 120 deg) using CADCAM on a Machining Centre. The thickness is 18mm the OD is 1000mm the ID is 750mm. The tool is 12mm diameter. The most efficient (on screen) method of utilising nesting and minimum tool operations is to make a snake of three sectors - spaced by the tool...

Steel Stud Support [ 5 Answers ]

I'm doing a shower remodel in an apartment, can the steel studwall support the large handles required for disabled access into the shower stall?

Stud wall topplate attached to steel joists [ 2 Answers ]

Hello I need to construct some extensive, but not load bearing, stud walls in our workshop. Trouble is, the mezzanine against which I want to secure the top plate is a steel girder construction, approx 3 metres off the ground. I'm guessing it will affect the integrity of the steel if I...

View more questions Search