Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing a ceiling fan (hunter 27144) wires
[ 1 Answers ]
I have a hunter ceiling fan (The Strafford/ 5 minute fan; Model 21311; Item #119--274) that I want to connect to a Hunter Universal Remote ( Model 27144-060). The ceiling has the following wiring: White wire, green wire, red, black, and a copper wire The Fan housing has the following...
Missing B and O wires for connectint to a Hunter 40170 thermostat
[ 2 Answers ]
I am replacing a white rodgers thermostat with a Hunter 40170. The wires have all been marked but the old thermostat does not have wire connections for the B and O terminals. These are for heat and cooling reversing valves. Where do I go from here. Will it work without wires in these terminals? I...
Wiring a Hunter Fan with only 3 wires
[ 3 Answers ]
I am wiring a new addition. I am installing a Hunter ceiling fan and light kit. I have a three way switch for the light and then a single pole switch for the fan. I found a three way diagram for the light part, but I am confused as to how to wire the fan switch. Here is what I have so far. On...
Janitrol 7 wires to Hunter 44550
[ 10 Answers ]
Hello, I studies everything from manual and website.. but I couldn't find specific information I need before I replace the thermostat. Ok, what I have is Goodman A42-15 with Janitrol 7 wires thermostat, which labeled below: Y, G, R, O, W2, E, C And for Hunter 44550 labeled: W, RH, RC,...
Installing Ceiling Fan Wall Remote with Red & Black Wires?
[ 13 Answers ]
I am trying to install a Hampton Bay Wall Remote Control that transmits a signal to a receiver that I will install behind the Ceiling Fan assembly. Problem: Remote instructions state to connect the 2 Black wires from the wall switch to the new Remote switch. The wall switch has a Red and a... View more questions Search
|