Ask Experts Questions for FREE Help !
Ask
    jbfaith's Avatar
    jbfaith Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 26, 2009, 06:16 PM
    Installing a ceiling fan (hunter 27144) wires
    I have a hunter ceiling fan (The Strafford/ 5 minute fan; Model 21311; Item #119--274) that I want to connect to a Hunter Universal Remote ( Model 27144-060).

    The ceiling has the following wiring:

    White wire, green wire, red, black, and a copper wire

    The Fan housing has the following wiring:

    White wire, green, black and white, and a black wire

    The remote box wiring:

    Black (fan out), black (live in), white (common), white (neutral), red (light), and the remote wire.

    My question is what is the connection process between the remote box wires and the fan wires? I have a new home and this is the first ceiling fan to be installed. I have installed ceiling fans in the past but with out a universal remote connected.
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #2

    May 4, 2009, 10:35 PM

    Black-black, striped-red, white-white.

    Ceiling fan wiring - Ceiling Fans N More
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Missing B and O wires for connectint to a Hunter 40170 thermostat [ 2 Answers ]

I am replacing a white rodgers thermostat with a Hunter 40170. The wires have all been marked but the old thermostat does not have wire connections for the B and O terminals. These are for heat and cooling reversing valves. Where do I go from here. Will it work without wires in these terminals? I...

Installing can light-too many wires! [ 1 Answers ]

I'm installing a can light and need to know what wires to connect together. It's a newer house and the electrical wiring was capped off in this location. So I removed the cap to expose the wiring and there's too much going on. This can light will have 2 switches (one on each side of the room)...

Wiring a Hunter Fan with only 3 wires [ 3 Answers ]

I am wiring a new addition. I am installing a Hunter ceiling fan and light kit. I have a three way switch for the light and then a single pole switch for the fan. I found a three way diagram for the light part, but I am confused as to how to wire the fan switch. Here is what I have so far. On...

Janitrol 7 wires to Hunter 44550 [ 10 Answers ]

Hello, I studies everything from manual and website.. but I couldn't find specific information I need before I replace the thermostat. Ok, what I have is Goodman A42-15 with Janitrol 7 wires thermostat, which labeled below: Y, G, R, O, W2, E, C And for Hunter 44550 labeled: W, RH, RC,...

Installing Ceiling Fan Wall Remote with Red & Black Wires? [ 13 Answers ]

I am trying to install a Hampton Bay Wall Remote Control that transmits a signal to a receiver that I will install behind the Ceiling Fan assembly. Problem: Remote instructions state to connect the 2 Black wires from the wall switch to the new Remote switch. The wall switch has a Red and a...

View more questions Search