Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacement of Carrier Heat Pump Thermostat with Honeywell TH6000 series thermostat.
[ 4 Answers ]
I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...
Is thermostat blue wire needed?
[ 5 Answers ]
I'm replacing a old thermostat with a new digital Honeywell one. On the old one both the Yellow and Blue wires are connected to the Y screw. I also have a green, red, and white. The new ones instructions say do not use wires marked B. This one is not marked B but I figure it refers to the blue...
Thermostat turns on furnace and then thermostat shuts back to HOLD
[ 7 Answers ]
I believe that when we re-run the program with the correct date and time, if the temp has to go up, the furnace runs until it gets the appropriate temp, then it turns off and when it does that, the thermostat also turns off going to the HOLD state.:confused:
Help needed with Noma Programmable Thermostat
[ 2 Answers ]
Our old UPM Programmable Thermostat starting acting strange last night. Although the heat was set to 20, the heater continued to pump hot air into the house until it was 26. We struggled to turn it offf and finally turned it off downstairs at the actual furnace. When I called for repair, I was told...
Wiring help needed- new hunter thermostat
[ 6 Answers ]
I have an old 1980 era mercury analog thermostat, and want to replace it with a programmable one. The system coontosl a gas furnace with external compressor. The old t-stat is a general electric, and has the following wire conventions: Wire Terminal Green G... View more questions Search
|