Gas dryer flame

poppit12345 Posts: 1, Reputation: 1

New Member

Mar 17, 2009, 07:20 PM

Gas dryer flame

How to adjust kenmore gas dryer flame height

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Mar 18, 2009, 11:07 AM

Use as manometer (pressure tool) and adjust to factory spec on label of unit.

Add your answer here.

Check out some similar questions!

Maytag gas dryer SDG3606AWW, no flame [ 1 Answers ]

When the dryer is cool the flame will come on but after 3 or 4 minutes it goes out and will not lite again, the igniter comes on but no flame.

Dryer won't keep flame on. [ 2 Answers ]

When the dryer turns on the igniter heats up and the flame lights but after a few seconds the flame goes out. I replaced the flame sensor but the same thing still happens. There is some sort of sensor on the heating tube but on Appliance Parts Pros.com Discount Appliance Parts – Appliance Repair...

Gas dryer trouble with flame [ 1 Answers ]

My Kenmore gas dryer takes 2 or 3 cycles to do what it used to in 1 cycle. Observing the flame, it runs about 45 seconds then cuts off even with a full wet load. It will cycle back on then shut off again after running about 45 seconds. I suspect that either the thermal limiter, wherever that is, is...

Maytag gas dryer flame on 10 sec per 1 minute. [ 2 Answers ]

I have a Maytag gas dryer, model number DG9800. When turned on the tumbler will rotate, the flame will ignite for about ten seconds, go out for a minute, then reignite. The high limit thermostat is what opens and closes the gas valve. The vent line is clear. It takes a LONG time to dry a load...