Ask Experts Questions for FREE Help !
Ask
    oldwarrier's Avatar
    oldwarrier Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Mar 8, 2009, 02:36 PM
    Rotary switch wireing
    I have a Indak Rotary 4 position switch part # 2G754A. Can any one tell me how to wire to a fan, or are there wireing diagrams available some where. Thanks Bill
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Mar 8, 2009, 03:45 PM
    This may help:

    http://www.indak.com/products/standa...pos_square.htm
    oldwarrier's Avatar
    oldwarrier Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Mar 8, 2009, 04:22 PM
    Thanks Statmando. Yes I was in that site. The trouble is I could not find a wire diagram. I am not using this for a fan so I need to know what each post is for. Thanks Bill
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Mar 8, 2009, 05:00 PM

    That switch is the top of the list, and it shows the circuits made(contacts)Poor info as photo shows numbers, and list uses letters(idiots)
    A meter can identify which is which through a few test, You won't be able to use it as your standard 4 position Rotary.
    Weed's Avatar
    Weed Posts: 2, Reputation: 1
    New Member
    		  
    #5

    Nov 21, 2012, 08:32 AM
    You think you have problems, try finding a plug to fit the 5 posts.
    Weed's Avatar
    Weed Posts: 2, Reputation: 1
    New Member
    		  
    #6

    Nov 21, 2012, 08:48 AM
    The posts are labeled B = battery L= lo M= medium H= high and C = ? Usually not used. Lo-Med-and Hi usually go through an Indak resistor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rotary switch wiring diagram [ 4 Answers ]

I purchased an old rotary switch, unfortunately without a wiring diagram. It has four settings (off, low, med, hi), and four wiring poles. Contacts rotate at two levels and connect the poles as shown in the attached JPG. My question is how to wire this thing (I assume there are three incoming...

Ceiling fan wireing for pull switch [ 1 Answers ]

I have a hampton bay ceiling fan the four wirepull switch for the fan broke I bought a new switch took apart old one don't remember which wire goes were I have black ,blue yellow,white wire and on the switch it has a L,1,2,3

Wiring a 3 speed fan switch (mechanical rotary type) [ 1 Answers ]

My Hampton Bay pedestal fan has a 3 speed rotary switch that broke apart. I was able to reconstruct it but I'm not sure of the wiring. It's terminals are labeled with L, 1, 2, 3 and I have black, white, brown and red wires coming from the fan motor. I'm pretty sure "L" is the black wire but...

View more questions Search