Ask Experts Questions for FREE Help !
Ask
    theotn5's Avatar
    theotn5 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2009, 02:47 PM
    Replacing water pipe in basement wall
    My outside spicket is leaking, I need to know how to get the old pipe out of the basement wall center blocks and put the new one in. the connection inside in easy to get to. But the outside in concreted up around the pipe.
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Feb 24, 2009, 03:10 PM

    Can you post a picture, you may not need to replace the whole assembly may need to replace the washer,Thanks.

    John
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Feb 25, 2009, 09:38 AM

    Where do you live and do you know if this is a frostproof spigot?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Proper way to install copper pipe through basement wall [ 2 Answers ]

I am putting a new water supply line in the older home we just purchased. There was a 3/4" galvanized pipe running from the city main to the water meter in the basement. I am replacing the galvanized pipe with 1" copper tubing. The galvanized pipe had rusted and holes in it where it went through...

Daylight basement water leak, cause by broken water pipe or saturated ground water? [ 1 Answers ]

I have a 6 units 3 stories with daylight basement apartment. Build in 1960. Just bought it few months ago. Last year the previous owner had a bad flood in the daylight basement after long period of rain. They cleaned out the area, remodel it. Good for few months, last couple of weeks rain long...

Replacing tub spout but pipe not square with wall [ 12 Answers ]

I took off the old tub spout and am replacing it with a new one... just a simple universal one that has a diverter. Thought that this would be an easy task, but the pipe stub isn't square with the wall, so when the spout is installed, there is about a 1/4" gap on the top between the wall and the...

Replacing a short section of ABS pipe under the basement floor [ 11 Answers ]

How can I replace a 24 inch section of ABS pipe (shower drain pipe) when the sections I am connecting to are rigid? I've heard of using 4 90's but surely there must be a way to do this without tearing up any more concrete than I have to?

Replacing tub in 3 wall alcove, trouble reaching drain pipe [ 3 Answers ]

Hello I have a old tub that I want to replace that is located in a 3 wall alcove. The supply side of the tub has a 6'' thick cement wall blocking access to the drain system from the backside (house is built on slope, 20y old and this is on bottom floor which is cement, no crawlspace that I know...

View more questions Search