Ask Experts Questions for FREE Help !
Ask
    daslocumb3's Avatar
    daslocumb3 Posts: 2, Reputation: 1
    New Member
     
    #1

    Aug 19, 2006, 05:32 AM
    Low pressure
    I have a 1 year old house on a well that has good pressure in the master bath(which is right above where the well comes in and the pressure tank), but on the other side of the house (38') I have very low pressure. This is on the first floor. The second floor has good pressure. I have 3/4 inch thompson flow guard piping until it t's for the second floor, then it reduces to 1/2" piping for a 20' run. How can I increase pressure to my kitchen(where the low pressure is)?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Aug 19, 2006, 06:49 AM
    Have you removed the aerator from the kitchen faucets spout and checked the screens for a clog? Have you shut the water off, disconnected the supplies and turned the water back on for a minute to flush out the supplies and ascertain if the fault is in the supplies or faucet? Let me know. Tom
    daslocumb3's Avatar
    daslocumb3 Posts: 2, Reputation: 1
    New Member
     
    #3

    Aug 19, 2006, 07:25 AM
    I have cleaned the screens, but not the supplys. I'll try that. Thanks

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure/bladder tank losing pressure? [ 11 Answers ]

Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions...

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...

Low pressure [ 3 Answers ]

Ok, I have a rental house, got good pressure in the bath room on hot and cold, and in the kitchen got good hot water pressure. The cold in the kitchen is low. Any good suggestions at first places to look.

Low pressure on hot tap [ 5 Answers ]

Hi can anyone help I have just installed a new mixer tap on my kitchen sink with a removable shower head the cold water is fine but the pressure on the hot is terrible is there any way to make it better?

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...


View more questions Search