Ask Experts Questions for FREE Help !
Ask
    djcaudle's Avatar
    djcaudle Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 14, 2009, 11:19 AM
    Well pump
    I just installed a new well pump, but I can't get it to run steady and I won't build pressure. What do I do?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Feb 14, 2009, 12:25 PM

    Three questions:

    Is this pump above ground or submerged?

    How deep?

    Why did you replace the pump to begin with?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Submersable Pump - 220 volt - Capacitor Overheating - Pump Shutting Off [ 16 Answers ]

My 220 volt submersable well pump stopped working. We took the capacitor in to be checked one day and it was fine. The next day we took the relay in and it checked out. The following day I pressed on one of the wires that goes to capacitor and the well came on. The wire was old so I knew it...

Can same sprinkler pump serve as wet riser pump? [ 2 Answers ]

In a high riser building of about 100m height, a dry riser system is not visible as the firemen's vehicle can't pump water up to 100m. As such, av decided to have it as Wet riser. At same time I don't want introduce a separate pump to avoid over bloating of project cost. My sprinkler system must...

3/4 h.p. Pump control box running 1/2 h.p. Pump? [ 1 Answers ]

Will a 3/4 hp submersible pump control box run a 1/2 hp submersible pump?

Pool pump and booster pump timer diagrams [ 2 Answers ]

I am looking for a diagram that shows how to hookup two intermatic timers to the pool pump and the booster pump. Running 220volts

Sewage pump/ejector pump [ 2 Answers ]

My sewage/ejector pump sometimes won't shut itself off. It has gradually gotten worse as time goes by. What could be causing this? Any suggestions appreciated.

View more questions Search