Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I'm having big problems with my drilled well.
[ 1 Answers ]
I need to know if I've got shafted or not? From an expert in the field of drilled wells? I had a 6in well put on my land with a half horse in well pump and pessure tank in the well. Cost me a bit over $5000.00. Well three years later we built our house on the lot about 140' from the well. Since...
Tooth too small for a crown - dentist wants to trim down my gums
[ 1 Answers ]
I'm located in South Korea and I've had a really bad tooth for a while so I decided to take advantage of the national health care and see a dentist about my tooth. I was informed that I needed a crown and "nerve treatment". From the tools that the dentist was using I recognized the files as the...
Drilled into PVC Pipe
[ 2 Answers ]
While drilling a hole to hang a towel rod in a first floor bathroom, I drilled into the PVC waste line that comes from the upstairs bathrooms. I cut away a section of the drywall and can see I hit almost dead center into a 2 or 3 inch PVC waste line. The hole is approx. 1/2" in diameter. Is there...
Drilled well pump question
[ 8 Answers ]
I have a drilled well with the pump feeding a pressure tank(wx-202)... the pressures are set at 30/50psi... but when the well pump kicks in there are air bubbles that make my faucets sputter and spit... I suspected there was a air leak in the well pump to pressure tank line but wouldn't I hear a...
Drilled Wire
[ 1 Answers ]
I nicked an electric wire with a drill bit mounting a shelf on the wall, it blew a breaker. I have reset breaker and the circuit is working fine. Should I tear into wall and repair the wire? Thanks for any suggestions John View more questions Search
|