 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Honeywell RLV430A Prog T-Stat Wiring
I am trying to install the HW Model # RLV430A - My old T-Stat is round manual HW - the wiring in the wall consists of 4 wires: (1) each - red, green, yellow, white. The new has 2 black wires only - I need to know how to combine them and the instructions w/the new T-Stat was not helpful. Our heating system is propane forced air. Any advice??
|
||||
Check out some similar questions!
Can anyone tell me how to wire up this new frost stat
I'm switching my old stat to a new one that lets me enter a program. I have an electric central air furnace and a thermopump outside that provides heat and AC. I'm going from a honeywell CT3600 or so (looks the same as in the manual for that one but without the program buttons) to a RTH8500....
I am at my witts end with trying to wire this T-stat I am removing an old honeywell heatpump M# T874D1165 and replacing it with an RTH7400 programmable I have 7 wires running out of wall, here's what I have, BROWN and WHITE hooked to W-2 (with jumper going to Y-2) YELLOW going to...
I want to replace my Trane Weathertron tstat with a Honeywell RTH7400 prog one. I have a Trane heat pump with aux heat. I've been poring over these thread piece-mealing some info the follow is the result. The old wiring scheme: X2 - black O - orange G - green Y - yellow T - tan/brown R -...
My system consists of a heatpump(amana ) / air /gas furnace. I'm presently using an amana stat (T874tg189910574101 ) and plan on changing to a Honeywell 7400 5-1-1. The amana stat uses terminals: e jumpered to w2 with tan wire , g , c / x , r , y , and o. The honeywell diagram only shows 5 wires...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
