Ask Experts Questions for FREE Help !
Ask
    jhammond50's Avatar
    jhammond50 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 15, 2009, 07:36 PM
    Bryant Furnace cycles several times
    My Bryant furnace cycles several times before it will reach the set temp on the stat?
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #2

    Jan 15, 2009, 07:38 PM

    What is the condition of the filter?
    jhammond50's Avatar
    jhammond50 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 15, 2009, 07:44 PM

    Changed before XMAS
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Jan 15, 2009, 07:53 PM
    Watch the furnace when it cycles. If the burner actually goes out then you have a weak limit control or the furnace is overheating causing the burner to cut out.

    OR post the exact model of your thermostat. If it is in recovery mode this can happen.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #5

    Jan 15, 2009, 07:57 PM
    You should have a flashing light telling you if you have a fault. Check the small round window on the blower door of the furnace, you should see a flashing red light.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 80 code 33 and cycles [ 8 Answers ]

Hi, I've got a ten year old bryant plus 80 furnace that, reads a code 33 while it cools, it is a solid while fired up but it constantly cycles. I've checed the condenser it looks clean on both top and bottom , filter is clean, all returns are open. Would making anouther return somewhere in the...

10 yr old bryant furnace doesn't always ignite smell gas [ 2 Answers ]

I have had a couple people look at my furnace and can't afford to pay the Bryant team! I replaced blower motor 2 years ago, furnace seems to run great once on, but when it kicks on sometimes I smell gas before and after cycles! I had to replace the inducer cooling fan, 3 weeks ago, now the smell...

Bryant furnace does not come on [ 3 Answers ]

We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house. When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners...

Bryant furnace starts then stops [ 3 Answers ]

My Bryant forced hot air furnace gets the signal to ignite, the pilot light and then the furnace lights but it goes out in a few seconds. This will happen over and over and then occasionally it might stay lit and warm the house. Any ideas of what this could be and how to fix it. Much...

Gas furnace runs two cycles [ 1 Answers ]

My gas furnace is approx. 30 years old. The furnace will run one cycle, shut off and approx. 15 seconds later run again for a shorter period. Everything is working properly, heating correctly etc. but runs two cycles. Any thoughts on why?

View more questions Search