Ask Experts Questions for FREE Help !
Ask
    majdavis's Avatar
    majdavis Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 14, 2009, 01:35 AM
    Boiler Burners will not stay lit
    I have a honeywell smartvalve sv950. I have replaced the igniter and the burners light and then go out. Also the fan is always on. What can cause this?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 14, 2009, 05:23 AM
    If the burners come on and then go right out the flame sensor might be to blame. They do get dirty buy since you have a smart valve and probably a smart valve flame sensor they could be difficult to clean with sand paper.
    This set up is delicate so do not get around the ignitor part just clean the sensor part. Post back with results.
    Attached Images
      

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Boiler burners light then shut off immediately, 5 minutes, then repeats [ 4 Answers ]

I have a gas boiler that from a cold start (first calls for heat) it will fire correctly, circulator will start running, and the burners stay lit until the set temp is reached. When the burners shut down the circulator will continue to run for several minutes. What I have noticed however, is that...

Rheem boiler burners will not fire up [ 2 Answers ]

I have an older Rheem gas hot water boiler heater - pilot is on, and I have turned up the thermostat, which appears to be working (saw a spark in the mercury when I turned it up) - burner is not coming on - what's wrong?

Burners do not stay lit. [ 3 Answers ]

Burners do not stay lit. I have a brand new Goodman GPG13 package unit with a 138,000 BTU natural gas furnace. The furnace has six (6) burners and an electronic spark ignition. All burners light, then (after about one (1) minute) the bottom burner or bottom two burners sputter or just go out may...

Why will my burners not stay lit [ 1 Answers ]

My forced air furnace does not stay lit when the heat is turned on. I climbed into the attic where it is located and had my wife set the thermostat to heat. I observed the burners light and watched the Honeywell limit switch start to do it's thing but after about a minute the limit switch...

Burners won't stay lit [ 2 Answers ]

-- need more help in figuring out flame sensor or roll out switch - Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)---burners light for 1 or 2 seconds, then go out


View more questions Search