Ask Experts Questions for FREE Help !
Ask
    akhoot's Avatar
    akhoot Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 26, 2008, 12:19 PM
    Duel heat thermostat wiring to air handler and oil burner
    I have the following system I am trying to wire...

    Goodman Heat pump gsh140361a
    Goodman air handler aepf30361a
    Visionpro th8320 thermostat
    EFM oil burner
    Outside thermometer

    I am attempting to set up my system to run the oil burner as the secondary heat (below 40 degres) and I am unable to get my airhander to turn the fan on with the oil burmer---I think the rest of the system is operating OK, but if someone is familiar with setting up this type of system can help, It would be appriciated.

    Thanks,
    Mike
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Dec 26, 2008, 02:29 PM

    Check thermostat configuration options for a selection that powers "G" terminal with any "W" output. Enable this option.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

A/c thermostat wiring air handler and condenser [ 1 Answers ]

The air handler tells the condenser what to do,how do the wires go? From the t-stat yellow,red,green,white,blue! From the condenser,red and white?in the air handler red,white,green,blue,orange,brownand yellow what goes where and how do they connect

.Heat only thermostat wiring. [ 2 Answers ]

I have an existing stat that has two wires coming out of the back. A blue one and a black one. The black is hooked to a black one in the box and the blue is hooked to a red in the box. On my new LUX LV2 stat there is a red line wire on the back and a black load wire on the back. What do I...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Thermostat wiring for heat pump [ 1 Answers ]

I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?

Heat pump thermostat wiring [ 1 Answers ]

I have pored over the thermostat wiring messages on this forum, but I still have a question. I am installing a RiteTemp 8085C to replace a Janitrol thermostat for my Goodman heat pump. The old thermostat was wired as follows: Red to R Orange to O Yellow to Y Green to G Blue to C White...

View more questions Search