Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Frost on interior walls
[ 17 Answers ]
We've been in our home for nearly three years. Don't ask me how I've noticed this before but we actually get frost on a couple of areas of the downstairs walls. Also there is a lot of cold air moving around the bottom of the baseboards in the downstairs. Anyone know causes and solutions for...
Interior shower wall
[ 2 Answers ]
I just finished insulating an interior shower wall and will start cutting the hardi backerboard to go over it. Do I have to put up a vapor barrier or can I just red guard it before installing the 12x12 porcelain tiles? Also is Versabond fortified thinset mortar the correct mortar to use? I will be...
Framing interior door in non bearing wall
[ 1 Answers ]
Can I toe-nail header into a bearing stud (king) on one side and use jack and king on other to keep door tight to one side of an existing opening that I am making smaller?
Remove an interior wall, install arch
[ 1 Answers ]
I am looking at removing an interior wall between my kitchen and living room and installing an archway in its place. It is not a load bearing wall. Is this difficult to do? How would I go about starting?
Removing an interior wall
[ 3 Answers ]
I am Renovating my kitchen and am removing the wall between the kitchen and dining room. The roof is constructed with W trusses that span the entire house. The wall rests beneath the middle of the trusses, but only halfway along from an exterior wall. After searching on-line for a while I have... View more questions Search
|