Ask Experts Questions for FREE Help !
Ask
    jfuduric's Avatar
    jfuduric Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Dec 8, 2008, 10:24 AM
    Dryer won't turn off in auto dry mode
    Where is the sensor on a Kenmore electric 70 Series?
    Could a defective timer be the cause?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 8, 2008, 10:41 AM
    Usually the sensor is located in the drum area. Some systems also have a sensor relay located in the control panel. The timer could also have defective contacts for the sensor circuit. Sorry I cannot be more clear on this but there are so many different setups over the years it is difficult to be extremely accurate as to locations. To test these circuits you will need a meter and know how to use it and also a wiring diagram and service manual to tell you what the readings on the meter mean as to the parts (weather bad or good). Most homeowners cannot work on these systems since it is electronic in design. Now replacing a belt or other mechanical is usually no problem. Sorry I cannot be of more assistance.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Dryer does not dry in Auto Dry mode [ 23 Answers ]

My Maytag dryer works well in the Timed Dry mode but in the Auto Dry mode it runs forever and does not dry well. In the Timed Dry mode it produces plenty of heat and works fine. What is happening in the Auto Dry mode that does not make the heat properly get to a level that allows the clothes to...

Thermostat Q - Blower Does Not Turn ON in FAN Auto Mode [ 10 Answers ]

I just installed a NOMA 7-day programmable thermostat for an electric furnace/AC system (ceiling unit). I believe the wiring (5-wire) is correct. When I set it to COOL with Fan set to AUTO, it turns on the A/C and the fan automatically. Good. But when I set it to HEAT with Fan set to AUTO,...

Gas Dryer won't dry in auto mode [ 1 Answers ]

I have an Amana Gas Dryer (PLG8409W2) which will not stay hot. In the Auto Dry mode the following ocurrs: The igniter will glow and the gas will flow and ignite. After a while (depending on the load) the flame will go out, it might then glow and ignite the gas flow again. At some point the...

Maytag dryer not working in auto dry mode [ 1 Answers ]

Have a circa-1998 Maytag gas dryer (model LDG8410AAW). After cleaning out exhaust vent thoroughly (as well as replacing belt), having problem where the auto dry mode is not working on the timer (the other timed mode, however, does work). Should I replace the timer, or is there a sensor that needs...

Furnace turns off at 'ON' mode and will not operate at 'AUTO' mode [ 6 Answers ]

The furnace will not turns on at "ON' mode. After some reading, I thought it would be the pilot light that has gone out. I re-lighted the pilot light to see blue-red flame, but the furnace will turn off AGAIN after 3-4 hrs. Replaced a new Honeywell non-programmable thermostat today with the...

View more questions Search