Ask Experts Questions for FREE Help !
Ask
    data12345's Avatar
    data12345 Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Dec 5, 2008, 03:36 PM
    My lincoln 225 gas welder 16hp single cylinder
    How do I disconnect the motor form the generator. Is there some type of method of doing this, If someone know please email me with the answers @ [email protected]:):)
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Dec 5, 2008, 03:47 PM

    Hi,
    Specialized tools required. The unit has the equivalent of a generator in it with all the associated circuitry. It must be opened up, have the endcap removed. The retaining bolt remove for the rotor and then a slide-hammer with the proper end must be used to remove the rotor. The rotor is mounted on a tapered crankshaft, which requires the slide-hammer.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs & Stratton 18.5 HP OHV Intek Plus - Single Cylinder [ 8 Answers ]

Help! I just replaced the short block on this motor and I cannot get it to run. I've adjuseted both intake and exhaust valves to 0.004 at 1/4 turn past TDC and no luck. It cranks over and kicks back on the compression stroke with smoke out the carb. So far it has not kicked over at all yet. What...

Wiring for Lincoln Mig Welder [ 1 Answers ]

How do I do the wiring for 230 volt Lincoln Mig Welder?

B&S starter gear, 16hp cast iron single [ 3 Answers ]

Have a 16hp B&S single cyl cast iron motor that continues destroying the starter gear. Motor has aluminum ring gear and plastic/fiber starter gear. After several starts (3 to 10) it destroys the teeth on the starter gear. I'v checked with my dealer and the parts are correct #s. The ring gear was...

Wiring my garage for a 230 VAC single phase welder [ 3 Answers ]

I am trying to wire a 220 outlet for my 230VAC single phase welder in my garage I have a 60a double breaker is it as simple as black and white w/ red stripe wires to breaker and green to ground? Thanks for any help

View more questions Search