Ask Experts Questions for FREE Help !
Ask
    btucker12's Avatar
    btucker12 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 22, 2008, 12:02 PM
    Goodman furnace setting or repair
    I have a High efficiency furnace. It is a Goodman Brand it indicates by 6 flashes that it has a open roll out. Is this a simple homeowner repair or solution.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 22, 2008, 12:48 PM
    Replace the roll out switch and test. If not capable of doing that then call for ON SITE service.

    This can be a serious condition with the flames rolling out of the front of the unit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace gmp [ 7 Answers ]

Ok. I can turn the thermostat to 72 and it will stay on 64 with the fan blowing constant. Burners aren't firing. On the control board for the furnace, there is a trouble shooting light that blinks to tell you what is wrong. It blinks four times which indicates an "Open Limit Switch", and it tells...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Gas furnace setting vacation [ 1 Answers ]

I have a new furnace for a seasonal cottage. The instruction book says that it should not be set lower that 60F/13C , as this might cause damage. I want to set it lower for when there is no one there-most of the winter. I left my old furnace (1970s) set at 10C and would like to do the same now. ...

PSI Setting for oil furnace [ 1 Answers ]

My furnace is about 15 yrs old and the psi is at 25. Is that OK or should it be at 20.

View more questions Search