Ask Experts Questions for FREE Help !
Ask
    Grand's Avatar
    Grand Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 6, 2007, 06:55 AM
    PSI Setting for oil furnace
    My furnace is about 15 yrs old and the psi is at 25.
    Is that OK or should it be at 20.
    juggallojed's Avatar
    juggallojed Posts: 165, Reputation: 10
    Junior Member
    		  
    #2

    Mar 7, 2007, 07:37 PM
    Quote Originally Posted by Grand
    My furnace is about 15 yrs old and the psi is at 25.
    Is that ok or should it be at 20.
    Contact the burner/pump manufacture... most of the oil units I work on are at 100 psi
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Miller Oil Furnace [ 3 Answers ]

I have a miller oil furnace that was installed in July of 2006 it has been running just fine until now I have power to it but it won't run. I can get the fan to start but when I hit the reset button all I get is the blinking light. Can you help:(

Beckett oil furnace [ 2 Answers ]

I recently switched from oil to gas in the house, and rather then get rid of the oil system, I decided to install in the garage. The system used to be a 2 line feed but have only one to it now the other being closed. The furnace will fire up, however fuel is spraying out from the inside near the...

Oil fueled furnace [ 1 Answers ]

I have a not even two years old oil fueled furnace. I realize that the burner is a independent part of The furnace. I was wondering, can that be changed for a gas fueled burner?

Lennox oil furnace [ 3 Answers ]

What is the proper procedure for cleaning a oil furnace, such as cleanouts to heat exchangers and where could I find a exploded view of a lennox oil funace

Oil Burner Furnace [ 1 Answers ]

The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is...

View more questions Search