Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower working,hot surface ignitor not lighting up
[ 24 Answers ]
My furnace is a Carrier,about 9 years old. My blower runs but there is no heat. Have done some research so I replaced the HSI because there was a white spot on it and it was not lighting up. It still is not lighting up. Could someone tell me what I should do next. Thanks.
Comfortmaker Furnace Hot Surface Ignitor Failure
[ 2 Answers ]
I have an 1989 vintage Comfortmaker furnace. Over the past couple of years, the burner goes out shortly after it starts up. When I replace the hot surface ignitor, it starts working again normally. I have had to replace the ignitor lately every one to three months. I have had a technician look...
Hot surface ignitor
[ 1 Answers ]
What would cause a hot surface ignitor to explode?
Cost to replace ball joints
[ 3 Answers ]
97 mercury AWD replace ball joints, what is the cost?
How much does it cost to tear down/replace a wall?
[ 1 Answers ]
I would like to knock down two walls from the kitchen to create a "great room" effect. I would like to join the living, dining and kitchen together but a friend advises that just this portion of the project will run well into 50k, which is my budget for remodeling the entire house! Does drywall,... View more questions Search
|