Ask Experts Questions for FREE Help !
Ask
    aroslinger1's Avatar
    aroslinger1 Posts: 35, Reputation: 1
    Junior Member
    		  
    #1

    Oct 27, 2008, 01:32 PM
    Pilot stays lit
    Pilot stay's lit now but still will not fire up
    Cleaned pilot orifice good and now have a good flame
    Put old thermocouple back in
    And has flame almost directly on it
    Be cause it at least worked half
    Still won't fire up
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 27, 2008, 04:00 PM
    You might need a new thermocouple. Also make sure the gas valve is turned to on and not left on pilot. Note you have to have the thermocouple in the flame or it will not generate a voltage signal for the valve safety control to lock on.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Goodman furnace igniter stays on 20 sec with pilot light [ 1 Answers ]

Have a Goodman forced air unit in my garage, was used only now and then, a while ago it started this... turn furnace on and igniter comes on and lights pilot then stops for a second then comes back on for about 20-30 seconds... all this time pilot is light and strong... then igniter stops and...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

Furnace Pilot stays lit continuously [ 1 Answers ]

My furnace pilot stays lit continuously Even though it states inside of the furnace and I quote "Pilot will light automatically when there is a call for heat. NOTE during thermostat off cycle main burners and PILOT flame are both extinguisehd. I have gotten many rude response that say that's...

View more questions Search