 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Coleman Evcon Furnace igniter
We have had to replace the igniter in our furnace at least 4 times in a little over a year. What could be making them burn out? We had two go out in just one weeks time! This was 12-25-07. We had a new one installed late April of this year so it wasn't used that much. We turned the furnace on last Friday (10-10) and on the 16th it wasn't igniting again. We are expecting our neighborhood repair man to give us a call today. He was gone for the weekend. We are seriously thinking of a new furnace! Thanks, M. Olson
|
||||
|
||||
|
No need for a new furnace but make sure that NO one touches the ignitor surface with there bare hands. The acid on your fingers make them go bad quickly. Like in your case. Also better ignitors are now available the hold up much better.
For the new style part number you will need to check with a supplier or wholesale house for HVAC. The kist are available for your furnace. I have included the link. From silicon to nitride conversion kit. http://www.white-rodgers.com/wrdhom/...ns/furnace.pdf NOTE: you might get rid of the neighborhood repair man since this could also be part of the problem with replacing ignitors so often. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(
My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...
I have a Coleman Evcon electric furnace in a mobile home I rent. Recently a wire had burned off which caused it to produce no heat. After they sent a repair man to work on it I now seem to not have as much air force coming out of the registers. Also it takes 20 minutes to raise the temperature one...
How do I know or rather how can I check to see if the repairman cut off one of the heating elements and where are they located?
Hi, Just found your site today-yipee! I have a problem with my Coleman-Evcon furnace (it has had A/C added)-just bought the house this year, but previous occupants said all was working before. When I turn on the heat on the thermostat, I get a code 3 readout, "Centrifugal Swithch Open"; I had...
View more questions Search
|
