Ask Experts Questions for FREE Help !
Ask
    gidget1964's Avatar
    gidget1964 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2008, 12:01 PM
    Coleman Evcon electric furnace
    I have a Coleman Evcon electric furnace in a mobile home I rent. Recently a wire had burned off which caused it to produce no heat. After they sent a repair man to work on it I now seem to not have as much air force coming out of the registers. Also it takes 20 minutes to raise the temperature one degree. Surely this couldn't be right. My electric bill was triple this month. I realise it has been colder but I have my thermostat set for 69 during the hours I am up and at home and 60 for the night hours I am sleeping. Does anyone have any ideas on this?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 19, 2008, 12:31 PM
    They could have cut off one of the heat elements which would cause the heater not to put out as much heat but the electric bill would be no different.

    There will be no miracle for your bill. Electric furnaces are very expensive to operate and as it gets colder will cost more.

    Sorry but there is no cure for the problem except to make sure all the windows doors etc are sealed correctly.
    richessigmann's Avatar
    richessigmann Posts: 3, Reputation: 2
    New Member
    		  
    #3

    Jan 14, 2012, 05:03 AM
    Did they replace a part on your furnace? Usually when a wire burns out it is due to a short and too much current traveling through the wire which heats it up. If you get on partsdirect and use the diagram to show which part the wire was going to, replacing this part "may" take care of the problem (if the service tech was not smart enough to replace it all ready, due to the short is should have been precautionary).
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman Evcon Electric Heat/Air unit filter placement [ 7 Answers ]

We live in a rented mobile home in Texas; the landlord requires us to change filters once a month in the heat/air unit, which is a Coleman Evcon. (There is no model number visible.) The filters were sitting tilted along the side, inside the case, when we moved in. We have lived here over a year and...

Coleman evcon furnace [ 5 Answers ]

My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...

Nedd fault codes for Coleman Evcon Furnace [ 4 Answers ]

I have a Evcon furnace model DGAA056BDTB and the cover plate for the controls box is missing. I am told that the fault codes were on the back of the plate. Where can I get a replacement cover or at least get the fault codes for my furnace?

Blower during furnace operation on electric Coleman Evcon [ 2 Answers ]

I just installed a programmable thermostat for an electric Coleman Evcon furnace. Now when the furnace comes on the blower also comes on. Sometimes the blower goes off a minute or so before the furnace stops. It never did this before- in fact I didn't even know there was a blower. Do I need to...

Centrifugal- Won't come on Coleman-Evcon Furnace- [ 2 Answers ]

Hi, Just found your site today-yipee! I have a problem with my Coleman-Evcon furnace (it has had A/C added)-just bought the house this year, but previous occupants said all was working before. When I turn on the heat on the thermostat, I get a code 3 readout, "Centrifugal Swithch Open"; I had...

View more questions Search