Ask Experts Questions for FREE Help !
Ask
    aquaman7527's Avatar
    aquaman7527 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 17, 2008, 02:08 PM
    Changing filter on Heil Furnace/AC
    My parents bought a Heil AC/Furnace in 2004 and it is time to change the filter. My father had been doing it but is gravely ill and doesn't remember how to do it. I looked at it and it has a bottom plate and face plate that comes off. I didn't see a filter in either one of these areas. Where is the filter located? Thanks to anyone who can help.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Aug 17, 2008, 06:26 PM
    A lot of times the construction filter in side the furnace is remove after installation of the furnace. The system will be filtered at a return air grill. Hope your father gets better. God bless
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heil Furnace [ 10 Answers ]

I have A Heil Furnace that starts up just fine Model #NDG1075DFo1, but after its running for 5 minutes or so it gets another call for heat, fills the gas box with naatural gas and re-lights this mix pretty violently. This may happen a few times during the heating cycle until the thermostat is...

HEIL furnace [ 1 Answers ]

Our heil furnace won't stay lit. It goes out after we release the pilot button. Any suggestion?

Add a fan only relay to my Heil LP furnace [ 3 Answers ]

I am adding an hydronic heat coil to my heil high efficiency furnace. I'm installing a 24volt relay wich I already have. I need to know how to wire this up. The furnace is a 1995 model. My objective is to run the fan on thermostat switch,and keep the LP heat for a back-up. Thanks

Heil furnace [ 2 Answers ]

I have bought a house with a furnace and I cannot get the pilot to light. I am asking for some type of manual so I can figure this out. The model is VG-80MD-1 and the serial is H73838067. The house was built in 1977 and I am sure this is the original Thanks for any info

Blower won't come on Heil furnace [ 2 Answers ]

I have a heil furnace in a home I just purchased. The first day it worked fine. Second day, it fires up, I can hear a motor running, but the blower doesn't come on. Relay switch? Thank You!

View more questions Search