HEIL furnace

incoldhouse Posts: 2, Reputation: 1

New Member

Feb 21, 2007, 08:15 AM

HEIL furnace

Our heil furnace won't stay lit. It goes out after we release the pilot button. Any suggestion?

lrd Posts: 1, Reputation: 1

New Member

Sep 2, 2009, 07:34 AM

Thermocoupler is bad - needs to be replaced.

Add your answer here.

Check out some similar questions!

Heil furnace short cycling of burner [ 1 Answers ]

My 1983 heil model NUGK075DG01, natural gas, forced air furnace is running but only heats the house to 67 degrees no matter how high I set the temp, the fan continuously runs (in auto on thermostat) and the burner will cycle for 3-4 min. then shut-off for 10 min.. I have powered down and back-on,...

Heil pa5542aka outside blower not on [ 1 Answers ]

From my previous question we found out when the power and light turned off the power when they turned it back on they forgot to turn the outside main breaker on after they turned the power back on. But, the heat works great now but the outside fan is not coming on. We just bought this place so we...

HEIL furnace will not stay lite [ 3 Answers ]

I have a older heil furnace (Model#867.769445) about 20 years old. When the pilot turns on after a few seconds the burners light, then after a second or two they shut off, on again, and off. They will do this continually until finally they stay on or the furnace stops trying to heat. I have also...

Heil gas furnace won't blow [ 2 Answers ]

I have a Heil heat/air gas pack(forced air) unit. It's about 20 years old, but it's been a great one. When I flip the t-stat to HEAT and AUTO I hear the unit outside firing up and I can see heat rising out of the vent, but the blower won't come on to push heat inside my house. When I turn the...

Heil 92% H9MPDO75F12B Gas Furnace [ 1 Answers ]

I had a Heil Gas Furnace installed and from the first day I notice that when the blower came on the air was on the cool side. After about 1 to 2 minutes the air became a little bit warmer but never got hot. My question is this normal or do I have a problem? Please let me know as soon as possible so...