How do I lite the pilot on a GE dryer, model#dx2300gboww

reggiex Posts: 2, Reputation: 1

New Member

Jul 11, 2008, 05:20 AM

How do I lite the pilot on a GE dryer, model#dx2300gboww

How do I lite the pilot on a GE dryer

progunr Posts: 1,971, Reputation: 288

Ultra Member

Jul 11, 2008, 09:24 AM

You don't.

Your dryer has an igniter/glow bar that lights the unit when the gas valve opens.

You may need to replace this part.

Add your answer here.

Check out some similar questions!

Intertherm gas heater pilot lite won't stay lit. [ 3 Answers ]

I have followed the directions, yet the pilot lite won't stay on.

Old American standard furnace pilot lite going out! [ 3 Answers ]

Will a universal thermocoupler work on it?. The one on there now seems to be a connected by a braided metal covered wire and connected to a power bar of some type.. . then a wire runs off the power bar to the 5/16 fitting... seems as though a universal honeywell thermocoupler would run direct from...

Carrier gas furnace model 58ES125-2d pilot comes on for 3 seconds clicks and goes off [ 1 Answers ]

Guys sorry for my ignorance its cold! Carrier 58ES125-2D or 5BES125-2d Pilot comes on for approximately 2-3 seconds clicks shuts off and retries over and over any ideas, may even click as it goes on? Thanks I cleaned it with steel wool and light sand paper, same thing pilot starts and goes out...

Bryant furnace blowing cold air and pilot won't lite [ 1 Answers ]

Hello, I purchased a Bryant gas furnace about 10 yrs ago. When I woke up this morning it was blowing cold air. My brother went down and looked at it and there was a red "led" light flashing on/off when he tried to get it to start back up. It was liting but now it isn't. Please help! :confused:

Gas fireplace won't lite,pilot light is on [ 7 Answers ]

I turned my gas fireplace on and the pilot lit fine and stays on but I can not get the main fire to go on. I have cleaned the thermocouple and other device on other side of pilot and also tried jumping the thermostat at wall and at fire place but no luck.