Ask Experts Questions for FREE Help !
Ask
    noname685's Avatar
    noname685 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 4, 2008, 08:15 AM
    Joining copper to PVC
    How do I join copper to PVC pipe?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Jul 4, 2008, 10:24 AM
    You solder a threaded adapter to the copper pipe, then screw on a PVC adapter, one is male threaded adapter, the other female. It matters not which is which.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Jul 4, 2008, 11:24 AM
    Yes, it does matter which end is male and which one is female. In this application, plastic should be male, copper should be female. In other words, you always screw weaker material into more solid material.

    Another option is as follows: Install "SharkBite" coupling. They are Home-Owner friendly. Both pipes just snap in. No soldering or glue is necessary. Home Depot sells them.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #4

    Jul 4, 2008, 12:32 PM
    Smearcase: Bingo ! Glad to be of service !

    ( Some claim "Shark Bite" fittings will eventually replace soldering... )
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #5

    Jul 4, 2008, 01:39 PM
    Here is the picture of the sharkbite couplingName: Shark-Bite-Coupling---Cash-.gif Views: 1419 Size: 17.1 KB
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sweating copper to copper valve connections [ 1 Answers ]

I'm replacing my shower with a Moen system that has a Moentrol three function transfer valve Model 3330. The inlet and outlets are copper to copper. Other than removing the cartridges prior to sweating is their any particular trick to heating those connections on the valve? Thanks very much for...

ABS/PVC joining [ 1 Answers ]

I am aware that Oatey makes a cement suitable for joining ABS & PVC DWV pipes. My question is why do some codes not allow joining the two unless a rubber fitting is utilized? Is there some bad chemical reaction between the two? Is there any downside to using the rubber fittings from an...

Copper pipes to cpvc: still ground the old copper? [ 1 Answers ]

Hi there... again... I have two copper stub outs that come into my garage, one the cold water in, which goes to my waterheater, and one hot water out, to the rest of the house, underground (slab construction). I will be re-plumbing my water heater and adding a bathroom from these lines, but I...

A/C not cooling, Small Copper pipe COLD and Large Copper pipe room temp. [ 4 Answers ]

I just moved into a newly constructed townhome and the a/c units are of course new. The A/c is not cooling at all. The machine inside turns on as well as the one outside. The inside A/C makes a strange sucking sound kind of like if you were sipping something out of a cup with a straw and you ran...

Joining Copper & PVC DWV [ 3 Answers ]

I am relocating my toilet (3 ft ). The current drain is 3" copper. How do I connect the PVC to the copper pipe?

View more questions Search