Ask Experts Questions for FREE Help !
Ask
    jaxboy's Avatar
    jaxboy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 27, 2008, 08:24 PM
    cracked compression nut on wall sink value
    While changing the wall sink valve, one value started leaking. Determined that the brass compression nut was cracked and the value was leaking. How do I get the compresison nut off and a new one on?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    May 28, 2008, 03:31 AM
    Hi jaxboy:

    You probably need to purchase a combination handlepuller/compression nut remover tool... see pic.

    Do not purchase JUST a handle puller... will not do the job! Must be a combo. Puller.

    Basically, the ears fit behind the nut, and the tip fits over/into copper pipe, then twist handle and should pull the sleeve off.

    These tools are available at all home supply stores.

    Good luck... MARK
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New Tiled Shower - cracked grout between shower wall and pan [ 4 Answers ]

I just spent 10K on labor alone to remodel my master bath. I purcahsed all Hand made tiles (Walker Zanger) and the contractor came highly recommended... After less than one month of use (and I did seal the shower walls and floor with a very good sealer), I noticed a hairline crack in the Grout...

Cracked coriane sink [ 4 Answers ]

I have a coriane kitchen counter top, with a double sink. The larger section of the sink is cracked all the way through to the bottom, and is leaking. I know that the counter top itself can be sanded when there are small scratches, but is there anyway to repair or replace this cracked sink? If so,...

Sink leaking at wall connection. [ 3 Answers ]

My bathroom sink is leaking where the exit pipe enters the larger pipe in the wall. When the water is running pretty hard, the water just pours back out. Is the pipe too long, too short or something else.

Compression fitting in wall and water heater connection [ 11 Answers ]

So from what I gather, it sounds like it's not recommended for in wall application. I guess I don't really need it to be in wall, and can just leave it unfinished. Just trying to hear what people think. Any code problems in Maryland? Now for the water heater. What I'm trying to do is move my...

Sink of solid surface cracked [ 2 Answers ]

Our sink that is part of a solid surface counter (not Corian, but similar) cracked. I didn't see or hear the crack happen, just noticed it. Any suggestions as to how we Can fix it without replacing the entire countertop?

View more questions Search