| 
 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
10HP Briggs and Stratton Generator Engine
 [ 24 Answers ]
 Hi Guys, Recently, I was using my Generac 5550 generator with a 10HP Briggs & Stratton OHV, model 204412, Type 0142 engine, and it started running rough and puffing black smoke. So I bought the repair manual. Took everything apart to the piston, cleaned the carbon off the pistons and... 
I can't pull the starter cord on my 10hp Briggs and Stratton Engine
 [ 6 Answers ]
 I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the... 
10hp briggs carb adjustment
 [ 1 Answers ]
 My snapper mower boggs down when blades are engagued runs good with no load. Have done all the tune up things carb clean twice ,plug,filter, gas , think carb may be out of adjust any suggestions or carb settings. Thanks. 
New 26hp Briggs & Stratton Engine Surges
 [ 2 Answers ]
 I just replaced the engine in my lawn tractor with a new 26hp B&S v-twin vertical mounted engine. When I advance the throttle from slow to fast, the engine surges, and I am unable to get full power. There is a rod near the throttle stop that moves up and down when the engine surges. When light... 
Toilet running and water surges
 [ 1 Answers ]
 I know absolutely nothing about plumbing, but I am trying to figure out why my toilet keeps having water surges about every 30 seconds. It makes a surging noise like water is coming in, and when I check it, the water is rippling. Before this the water constantly ran in the tank, and I adjusted... View more questions Search 
 |