Ask Experts Questions for FREE Help !
Ask
    303robert's Avatar
    303robert Posts: 2, Reputation: 1
    New Member
     
    #1

    Feb 13, 2006, 12:03 PM
    Basement Rough-ins
    I have a house that is 14 years old and it has rough in plumbing in the basement. One for the toilet and one for the shower. Also a stand pipe next to a wall which I assume is the vent. Does the rough in plumbing have the traps below the concrete flooring?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Feb 13, 2006, 12:20 PM
    Quote Originally Posted by 303robert
    I have a house that is 14 years old and it has rough in plumbing in the basement. One for the toilet and one for the shower. Also a stand pipe next to a wall which I assume is the vent. Does the rough in plumbing have the traps below the concrete flooring?
    Hey Robert,

    You have correctly identified all the pipes except one. The stand pipe next to a wall is a lavatory raiser. You will install a drainage tee 18" off the floor to the center of the tee on the raiser and stubout to pick up the lavatory. You will then come off the top of the tee to the roof to vent your bathroom group. The shower will be wet vented by the lavatory vent and yes it has a trap under the floor. The only trap you'll have to install will be a trap for the lavatory. Good luck, tom
    303robert's Avatar
    303robert Posts: 2, Reputation: 1
    New Member
     
    #3

    Feb 13, 2006, 04:34 PM
    I think I understand all of your comments and they are appreciated. However, I am confused with the following "You will then come off the top of the tee to the roof to vent your bathroom group"

    What is this?
    PalmMP3's Avatar
    PalmMP3 Posts: 321, Reputation: 28
    Full Member
     
    #4

    Feb 14, 2006, 01:02 AM
    He means that the "standpipe" can't just end in the middle of nowhere, and vent noxious gasses into the room; rather, the top part of the tee must also have a pipe atached to it going vertically - this one going straight up and [ultimately] out the roof (or later revented into a different vent stack).

    Hope this helps,
    Moishe

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Basement rough in [ 5 Answers ]

I would like to rough in plumbing in my basement for a full bath (toilet, sink, and shower). I live just outside of Chicago so I suspect the plumbing codes are the same as Chicago. Currently in my basement I have two sump pumps and pits, one pump takes care of the drainage around the foundation...

Basement rough in? [ 4 Answers ]

Hello, I just bought a house with a 3 piece rough-in in the basement. I am building a bathroom and as I prepare to do the framing work, I am wondering how much room do I leave from the rough-in toilet drain to the drywall? Any help would be appreciated. Thanks, Mike

Basement rough [ 11 Answers ]

Hi there I have a question about 2 4" pipes coming out of basement slab... one is raised and on is flush... both ate capped and connect directly to street... I'm prettty sure raised one is clanot but not sure about other... both emmit strong gas when caps removed?

Basement rough-in [ 3 Answers ]

I've seen a few of the posts w/ similar topics, and I think I'm on the right track. Just looking for confirmation from some experts. The center of the tub rough in drain is about 15.5" from the wall I'm puttting in and about 2" from the back wall I'm set to screw down. Question is, will a std....

Basement rough-in: dap out [ 12 Answers ]

Hello, I've spent the last 3 hours trying to figure out if my roughed in bath is missing something or not and wondering if I am going to have to redo any of my framing. I have the 4" and 2" drains in the toilet area and a 12"x12" dap out for the tub. Well I took the cover off the dap out to take...


View more questions Search