Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Do I HAVE to Dig and Bypass my Grease Trap?
[ 4 Answers ]
Our brick ranch house in the Denver area was built in 1952, and until recently we never knew it had a grease trap. The kitchen sink started running slow and our drain cleaning guy said the grease trap was near full and the best thing to do would be to locate it, (probably just outside the house in...
Double trap OK? Rough in piping + tub trap
[ 10 Answers ]
The way the 2" rough in went we ended up with a trap of sorts then a pipe to where the tub trap will be. Not completed yet. Just wondering if a tub trap and a trap made with the rough in piping will cause some sort of problem. The rough in trap was made off a 4x4x2 wye. Would that be adequate...
Replace P-trap with drum trap--good idea?
[ 3 Answers ]
Hi, I have a large crack in a cast iron waste line. The line at that point serves just the kitchen sink and is vented to the roof. The first plumber I called wants to disconnect the P-trap, install a drum trap, drill through the cabinet and floor, and connect to the waste line down below the crack....
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all... View more questions Search
|