 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Timing, starter, or distributor on a 1994 ford ranger
My 1994 Ford Ranger 3.0 L V6 onl;y has 100,000 miles on it. Sometimes when I drive it I will go like 10 miles or so and then if I park it and try to start it again like two minutes later it won't start. It will crank over but not start. But it only does it a couple of days a week. It's not the fuel shutoff switch either. I called a couple places and they thought it was the distributor module. I talked to some others who thought it might be the timing. What do you think? Does my truck have a timing chain or a timing belt?
|
||||
|
||||
|
It may be the ignition coil or even the fuel that is overheating. This is best diagnosed in first person. Whoever checks it will need to see it while it isn't starting. Checking things like proper power and ground is critical.
Your truck is equipped with a timing chain, not a belt. If it is need of service, you would be advised to replace the chain guides as well. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a '92 Ranger that won't start it just clicks one time. I thought it was the starter but it is good. I changed the battery terminals and that fixed one problem now it clicks until you turn the key off. I can't figure it out any advise? Thanks.
2001 Ranger. I found dangling down from left side rear a hose with a cilp. It was attached to the axle housing. What is it for and where does it go. It just appears to be some type of air hose but is not attached to anything at other end. Should I be concerned? Thanks
My 1994 Ford Ranger 3.0 L V6 onl;y has 100,000 miles on it. Sometimes when I drive it I will go like 10 miles or so and then if I park it and try to start it again like two minutes later it won't start. It will crank over but not start. But it only does it a couple of days a week. It's not the...
I have replaced the distributor and timing belt on my 1989 Honda Accord with a carburetor and it will only run with the distributor turned passed the stud mounts. I have made sure that the belt was replaced at top dead center.
Hey guys my problem is that I just swaped out a 2.3 for another 2.3 and when it runs it idles fine for a little bit then it seems like starts to miss then boggs out and dies and back fires like a cannon so bad it blew a brand new muffler out of round it kind of seems like it gets a rich smell of...
View more questions Search
|
