Ask Experts Questions for FREE Help !
Ask
    Z280Bill's Avatar
    Z280Bill Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2008, 03:15 PM
    Wiring a combination meter and main disconnect.
    I bought a Square D CQRA200 Meter/main disconnect combination and I expected to see the neutral isolated from the ground. Does the neutral and ground start from the same block?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Apr 4, 2008, 03:31 PM
    Yes, at the service disconnect the neutral is bonded to the case. This is the ONLY place this occurs.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Main disconnect breaker kAIC ratings? [ 4 Answers ]

Can I use a 10 kAIC main breaker in a main disconnect or does it have to be a 35 kAIC main breaker? I have a 10 kAIC, 225 amp breaker on hand, and I did not want to have to buy a new 225 amp 35 kAIC breaker if I did not have to. My indoor load center has a 10kAIC, but the outdoor, main disconnect,...

Can the CB in a subpanel exceed the ampacity of the CB in the Main Disconnect? [ 3 Answers ]

Can the main breaker in a sub panel exceed the ampacity of main breaker in the primary disconnect?

Changing meter main to sub-panel [ 1 Answers ]

I'm installing a 200 amp dual meter main. Can the old 100 amp meter main be turned into a sub-panel?

Meter Base with disconnect and A/C Breakers [ 3 Answers ]

My meter base will have an outside 200amp disconnect. It will also have three 30amp breakers to feed the A/C units located a few feet from the meter. There will also be a 200amp main panel located in the basement. My question is if my disconnect outside is a 200amp and I have three 30amp...

Main breaker and main disconnect [ 2 Answers ]

What I have is a home built in 1960 moved in 2 years it had a meter hanging from the rear of house with no main, 240v 50amp circuit to stove, 240 30amp to dryer, 5 breakers for the rest of house 1 20amp and 4 15amp. What my plan is to replace the meter housing and put a g.e. 200amp Disconnect on...

View more questions Search