Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Coleman Evcon electric furnace
[ 2 Answers ]
I have a Coleman Evcon electric furnace in a mobile home I rent. Recently a wire had burned off which caused it to produce no heat. After they sent a repair man to work on it I now seem to not have as much air force coming out of the registers. Also it takes 20 minutes to raise the temperature one...
Coleman electric furnace fan runs only in manual
[ 2 Answers ]
I have a mobile with a forced air Coleman electric heat. The fan will not run in the auto setting (switch by motor in cabinet) but the element will heat up. In manual the fan runs constantly and heat comes on with the thermostat. The heating company recently replaced the sequencers and said we...
Blower during furnace operation on electric Coleman Evcon
[ 2 Answers ]
I just installed a programmable thermostat for an electric Coleman Evcon furnace. Now when the furnace comes on the blower also comes on. Sometimes the blower goes off a minute or so before the furnace stops. It never did this before- in fact I didn't even know there was a blower. Do I need to...
Price estimate range on blower/fan for LP COLEMAN MOBILE HOME FURNACE
[ 1 Answers ]
I am on a fixed income and need to know the approximate price range to Replace the blower/fan on the Coleman Mobile Home Furnace Model #7680A Series 856, 80,000 BTU /HR input 64,000 BTU Bonnet Capacity Blower Part # recommended are: 7670-692 Med. 7660 - 693 Med. 7670-693 Med. Over the...
Coleman electric furnace
[ 2 Answers ]
I have a Coleman electric furnace in a mobile home. The furnace element turns on and heats up with the thermostat turned down to 50 degrees and with the inside temperature at 68 degrees. The thermostat doesn't click for the blower to turn on until I turn it up past 70 degrees. Why is the element... View more questions Search
|