Ask Experts Questions for FREE Help !
Ask
    cold comfort farm's Avatar
    cold comfort farm Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 18, 2008, 11:55 AM
    Vanguard V twin Hunting engine
    Hi all,
    I have a B&S vanguard 14hp ohv engine in my lawn mower. It has developed a problem of the engine hunting when driving and won't run unless the choke is out a little. The governor is popping up and down like a mad one, Any suggestions before it goes into the shop for an expensive repair.

    Thanks in Advance

    Stephen:)
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #2

    Mar 19, 2008, 09:42 AM
    Remove and clean the carb.
    SkipB's Avatar
    SkipB Posts: 41, Reputation: 2
    Junior Member
     
    #3

    Apr 3, 2008, 03:00 PM
    I agree with Mowerman but also check for worn throttle shaft bushings. If they are worn they will allow air into the carb. A quick check for this is to try and wiggle the throttle shaft, it should not move. Also spraying some carb clean around the shaft while the engine is running and see if you notice any response in the engine. Most kits include the new bushings.
    Tapan904's Avatar
    Tapan904 Posts: 2, Reputation: 1
    New Member
     
    #4

    May 11, 2011, 08:08 PM
    Try turnig on the mower without choke.. . may be there is moew gas in chamber that needs to come out as a white smoke... pull and push ckoke till u can than turn off the mower and than restart it with choke down... not pulled at all will less than half speed of engine.., if it kicks on than... it will let go of white smoke and than run fine... I have 17 hp unit and it woked with it.. a temp solution but some time all it needs is to flush extra fuel out of it...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing starter moter on 16HP V-Twin vanguard engine [ 11 Answers ]

I have a Briggs and Stratton 16HP V-Twin OHV Vanguard Engine I am repairing. I am trying to replace the starter motor. . The bendix of the starter motor is plastic and has broken teeth and therefore does not engage with the main flywheel anymore. In order to accomplish this task I have stripped...

Briggs and Stratton Vanguard OHV Engine [ 1 Answers ]

I have a new Briggs and Stratton 8000 watt generator powered by a Vanguard 15 hp overhead valve engine.Since it came from the factory it has a popping sound from the muffler as it runs. It seems as though there is a misfire. The spark plug has been changed and the spark is in spec. Service dealers...

16-hp vanguard v-twin ovhd-valve engine [ 2 Answers ]

Could you please tell how to adjust overhead valves on this engine??

16HP B&S Vanguard V Twin won't start [ 4 Answers ]

Hi My 16HP B&S Vanguard V Twin won't start. There was a thing with wires at the bottom of the carb, but when removing the carb to check for a blockage, the wire snapped off. However, this does not seem to prevent the float chamber filling with fuel. There is fuel being pumbed from the fuel pump...

16.5 I/c Briggs Twin engine problem [ 10 Answers ]

After rebuilding the deck over the last two months, now my Yard Machine 600 series tractor will not run properly. The engine will rev and die repeatedly when you try to cut with it. The carb was rebuilt last year and it has new fuel lines and filter. Is this an adjustment problem or is the carb...


View more questions Search