Ask Experts Questions for FREE Help !
Ask
    steelbender84's Avatar
    steelbender84 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 7, 2008, 09:31 PM
    Motor wiring?
    I have a new GE commercial motor model # 5KC35JNA489Y, 115v to replace the one on a metal lathe. It has 5 wires, purple, blue, black, white and yellow.. there is a separate switch for forward and reverse.. I'm not sure how to wire this.. any help would be very appreciated
    biggsie's Avatar
    biggsie Posts: 1,267, Reputation: 125
    Ultra Member
    		  
    #2

    Mar 8, 2008, 02:47 AM
    There should be numbers on wires -- hope this helps,

    http://catalog.wegelectric.com/img/Wiring_Diagrams.pdf

    I went to the Granger site and tried to get some information

    This is Saturday morning 3 AM I called them 1-888-361-8649

    They are 24/7 but techs and data base were not available
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Mar 8, 2008, 06:23 AM
    If it is a New motor, it should have connection diagram on Name plate, or under connection cover.
    Here is a couple more diagrams:
    http://www.gemremotes.com/pdfs/GEM_w...agram_7_07.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a GE electric motor [ 5 Answers ]

HI, I have a GE motor on my table saw that was wired for 220vac. I want to change it back to 110vac. Problem is that the wiring plate is missing. Motor number is 5KC49TG1458X IT'S A 2HP motor Currently it has the following wires connected motor has 4 threaded studs marked 1-2-3-4- Power...

Wiring an older GE Motor [ 1 Answers ]

I have an older 1/3 hp single phase ge motor with poles marked "1-5" and one marked "L" I am just wondering how to wire this motor to a 115VAC circuit.

Motor wiring? [ 4 Answers ]

:mad: Perhaps someone here can help me, I bought a small GE 120v electric motor for a replacement for a machine. It has 3 three wires (red, yellow,blue) and requires a 10mf capacitor. My best guess was to wire it with Blue to line , red-line & cap, and yellow on the other cap term. But it runs very...

Emerson Motor Wiring [ 2 Answers ]

I've read (most) of the similar questions about blower motor wiring, but haven't seen any that match my configuration. I have an Emerson 1/3hp, 3spd motor with the following wires: Red, blue, black, green (ground) direct from motor. White and brown go from motor to capacitor with black out of...

View more questions Search