Check out some similar questions!
Adding bath drain in concrete for existing half bath
[ 1 Answers ]
I want to turn a half bath into a full bath in my basement. Currently the washer and dryer along with the water heater are in the half bath along with the commode and sink. I want to add a bath tub and the lay out of the room is such that the tub installation would probably require less work if it...
Bath panel
[ 1 Answers ]
Hi Ive Got A 5mm Acrylic Bath But I Did Not Get A Bath Panel With It. I Want To Know Which Bath Panel I Can Use? The Bath Is 1500mm X 700mm
Kenmore Elite not cooling refrigerator side or side by side
[ 2 Answers ]
I have a Kenmore Elite Model 53609202 side-by-side. The freezer is working fine, the air flow into the freezer is working, the fan is on. There is another fan in the bottom rear that is also on. There is nothing in the refrigerator to block the vents. There is a little frost on the rear panel...
Putting a subpanel side by side with a main panel
[ 1 Answers ]
Hello, I am looking to put a subpanel side by side with a main panel. The sub panel will be connected to the main by a 1 & 1/2 inch metal conduit since the two panels will be electrically connected by the conduit - do I still need to separete the neutral and ground bus? Thanks, Martin
Cutting cement for plumbing 3/4 bath to full bath
[ 3 Answers ]
We are currently in the middle of changing our basement 3/4 bath into a full bath. The bathroom is 5.5' by 13.5'. We want to put the sink where the shower was and put a tub/shower where the sink was. (because the space where the shower was is too small for a tub). The old sink drain is centered 4... View more questions Search
Add your answer here.
|