 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Mansfield model 206 NEW won't flush completely
I bought a brand new Mansfield model 206 toilet. I need to raise the water level in the tank, but the only adjustment seen just turns the water on/off... using a screw. How can I raise the water level in the tank.
|
||||
|
||||
|
Hey club... that screw increases or decrease height of water in the tank. It does on all other fill valves.. so it should here as well.
Do you have a ballcock fill valve (with a 3 inch ball at end of rod)? OR do you have a fluidmaster type fill valve where float rises up and down the fill valve? Let us know... and fiddle around a bit with that screw... it is not supposed to turn water on/off... it is supposed to allow adjustments to volume of water entering tank (unless fill valve was set too low... but that would only be if fluidmaster type valve... see pic. Below (borrowed from Speedball1... our moderator ;)... is your fill valve anything like that fill valve on left? ). Get back to me |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi, I had just found this forum and this is my first post. My elderly parents live in a 2 story old home with two bathrooms, one on each floor. The toilet on the ground level flushes fine. The one upstairs will not flush solids without filling up a bucket of water and emptying it in the toilet....
Installed a new toilet in the basement, it was preplumbed for the shower, sink, and toilet when house was built (in 1986?). Toilet will not completely remove solid waste without flushing it several times and also has to be plunged, in addition, sometimes before it all goes down and toilet works...
I have a basement toilet and also a septic system. When flushed, the toilet fills almost to the top and then goes down like it normally would, but does not completely empty. Looks like a small water funnel twisting around, but just does not make that final "burp" as the water fully leaves. Have...
My toilet is not flushing. I'm not sure what is wrong as I have no toilet knowledge... so I'm going to give as much info as I have (not sure if its going to be useful or not!) I can empty a bucket of water in the bowl and it will flush, but it will not flush using the handle. It is a mansfield...
I just replaced all the insides of my toilet, now when I flush I have to hold the handle down until all the water runs out of the bowl. If not almost as soon as I let the handle go the flapper will cover up the hole that drains the water into the bowl. I know this is easily fixable, but I don't...
View more questions Search
|
