Ask Experts Questions for FREE Help !
Ask
    lisapawlak's Avatar
    lisapawlak Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 15, 2008, 08:35 AM
    Rheem Criterion II--heat cycle works, then shuts down
    Hi-

    I'm having a problem with my gas furnace and don't know where to start to find out what it might be. When the thermostat calls for heat, the draft inducer kicks on, the ignitor glows, the gas starts and burns for a short time and then shuts off. It tries this whole cycle again, with the same results. Sometimes the blower runs by itself with no heat.

    Can anyone make suggestions as to what this problem might be? I'm hoping it's a part replacement and not a big deal...
    Thanks in advance for your help!

    Lisa
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Feb 15, 2008, 06:38 PM
    If your unit has a flame sensor clean it or replace
    joesdough's Avatar
    joesdough Posts: 1, Reputation: 1
    New Member
     
    #3

    Dec 15, 2008, 10:17 AM
    Comment on hvac1000's post
    Not much help... if no flame sensor

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem Criterion II blower won't stop [ 4 Answers ]

I have a Rheem furnace and the low speed fan continues to stay on after the furnace has cycled off. When I disconnect the red wire (low speed wire), the furnace runs normally. I would imagine the switch for the low speed is open. Is the switch controlled by the IFC? Does the IFC need to be...

Furnace rheem criterion [ 1 Answers ]

Furnace blower fan and the pre blower fan come on at same time. And the ignitor won't light. Have to turn off power switch to stop both fans. I changed upper limit swith but still won't work. When it was working it was going great, returned and blower was running only but no heat. Thermostat...

My heat pump AC works but not on heating cycle [ 2 Answers ]

I live in a 2-story house in AZ and there are 2 Lennox (sic?) heat/AC pumps, one for each floor... it has 2 Honeywell TH8000 thermostats. Last winter there wasn't any problems but tonight it started getting cold so I turned it from cool setting to heat, I can hear relays in the TS click and it says...

Rheem criterion furnace [ 3 Answers ]

My air went out yesterday and I don't what to do... the motor outside is not working but the inhouse fan is work air is coming out of the vent but it is not cool. This happened in the winter and we had the heat ignaitor replace... help?? it 98 degree today

Rheem Criterion II Startup Problem [ 4 Answers ]

Hi List, I have a Rheem Criterion II model RGDG-05NAUER (w/ HONEYWELL Chronotherm III) that is acting up. Recently, it was having problem of maintaining the flame constant so I replaced the flame sensor that fixed the problem and now the flame stay lit but the heat sequence seemed to have...


View more questions Search