Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace Heating : Cold air blowing from vent from one level/ Warm air in the other
[ 1 Answers ]
Ours is a 2 level house (1995), both levels heated by the same furnace ( YORK Multiposition Gas-Fired Furnace MODEL P2MP 32-112 MBH OUTPUT) . We have two digital thermostats (Hunter Programmable type) located on each floor. We were out for a few days and when we came back the lower level is getting...
Wiring hydro air and heat on the blower and boiler
[ 3 Answers ]
Hi , I would like to know where do I make the connection on the blower unit for my hydro air - heat, when I use a aquastat to turn on the blower to operate during the heating cycle, is this the correct way of doing this. And also were do I hook up the wires on the boiler side I`am a bit lost when...
Gas Forced Air vs. Boiler
[ 1 Answers ]
I think I'm a little off the wall here since I haven't seen this question asked this way anywhere else, but here goes: Would anyone ever recommend replacing an existing gas/forced air heating system with a gas boiler and radiators for hydronic heat? I know that all things equal, I would...
Boiler air vent
[ 1 Answers ]
I'm installing another zone to my force hot water (baseboard) boiler. The initial installation has a shutoff valve and plug on supply and return so extra zones can be installed. On other multizone houses, I've noticed that each extra zone has an automatic air bleed valve on the high point of the...
Day & Night forced air heater keeps blowing cold air
[ 1 Answers ]
Yesterday my heater was working as normal. Today I replaced the filter in my Day & Night forced air heater. Later I bumped my thermostat when walking by it, but I'm not certain that this caused the problem. My heater turned on and blew hot air. I turned it all the way down, but the fan... View more questions Search
|