Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bathroom Hot Water Faucet Clunks and Kills
[ 4 Answers ]
When turning on the hot water at the sink in one of our bathrooms there is a single loud clunking noise and then the water immediately stops (if it started at all). This is for the hot only. Cold faucet works just fine. Is this simply in the faucet control itself or..?
Turn faucet on in bathroom but water run in slow stream
[ 3 Answers ]
Hello Everyone, I'm new to this forum. Can someone please direct me? I need to fix my bathroom sink. When I turn the water on a slow stream runs; the water doesn't come on full blast. It was running a bit more earlier but I adjusted the gauges underneath the sink and got the results above. ...
Bathroom faucet water hoses
[ 2 Answers ]
Hi All, I'm trying to install a new bathroom vessel faucet that came with 1/2 inch female hose connections to my angle stops which have the standard 3/8 connections. Lowe's & Home Depot didn't know what to do with it. I tried a converter fitting from a local plumbing shop but the connections...
Sudden loss of hot & cold water pressure in one faucet
[ 1 Answers ]
Recently the pressure in both the hot and cold faucets on one bathroom sink dropped to almost nothing. We replaced the very old faucet with a new one but it did no good. We still have just the tiniest trickle out of both hot and cold. The tub and toilet in the same room are not affected. The...
Air lock in bathroom water faucet
[ 3 Answers ]
I just drained my hot water heater in an attempt (only partially successful) to eliminate the noise as the water heated. I now have one bathroom with no water (except for a bare dribble) either hot or cold. All other faucets are fine and this was not the faucet that I had turned on upstairs to... View more questions Search
|