Ask Experts Questions for FREE Help !
Ask
    pattusa's Avatar
    pattusa Posts: 2, Reputation: 1
    New Member
     
    #1

    Jan 24, 2008, 11:01 AM
    Diconnect Intertherm FEH 015H
    I cannot pull out the Disconnect on the lower right side of the inside heating unit of the Intertherm FEH 015H 017H. Does it come completely out? Could it be stuck? It doesn't seem to budge and I'm not that much of a weakling. Thank you for any information. Patt aka pattusa
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 24, 2008, 06:36 PM
    The pull out part might have burned in or shorted causing the removal to be about impossible. You might need to have it looked at and replaced if necessary. Put a very very light amount of deox on the blades of the new one to lubricate and prevent that.
    pattusa's Avatar
    pattusa Posts: 2, Reputation: 1
    New Member
     
    #3

    Jan 30, 2008, 10:50 PM
    Thank you, HVAC1000. I've just gotten back from out of town. I appeciate your response.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm Furace [ 4 Answers ]

I have an Intertherm furnace with electronic ignition. When it kicks on it only burns for a couple of seconds. I have changed the module, gas valve, igniter,checked the exaust flue, and thermostat... Whats up, I'm stumped. monkeypud:confused: :confused:

Intertherm furnace [ 6 Answers ]

Hi I have a Intertherm Model MMHA 070ABHr-01 gas. Had a tech out replaced the ignitor/and adjusted it. Problem still is furnace calls for heat prepurge fan motor kicks?? In, ignites runs for 2-3 minutes kicks out fan motor starts runs for 30 sec shuts off. In the mean time the furnace has...

Intertherm furnace [ 1 Answers ]

I own a 1985 modular home and the intertherm blower fan on my furnace quit working is it too hard to fix or change?:confused: Also what is the cost to fix it?:eek: Please help!! :) Thank you Rachell

Intertherm Furnace [ 1 Answers ]

My pilot light comes on and ignites heat exchanger but when the cover closes the flames shut down. The blower works but heat exchanger will not stay lit. I have replaced the gas valve and the thermo couple. Suggested that damper valve needed to be adjusted - where is the damper valve


View more questions Search