Ask Experts Questions for FREE Help !
Ask
    philwthom's Avatar
    philwthom Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 22, 2008, 11:59 PM
    90 Honda Civic Drivetrain
    On Front Drivetrain can't get passanger side cv axel back in the rotor assembly what could the problem be
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jan 23, 2008, 02:26 AM
    See if this helps:

    1. Install outboard joint in knuckle; then, loosely install a new spindle nut.

    2. Insert inboard end of driveshaft into differential, until set ring locks in groove. Ensure inboard joint bottoms into differential and that set ring locks into groove of side gear.

    3. Install damper fork over driveshaft and onto lower arm. Install damper in damper fork, so aligning tab is aligned with the slot in damper fork.

    4. Loosely install damper pinch bolt, and a new damper fork nut with the bolt. The bolts and nut should be tightened with vehicle's weight on the damper. See Step 8, below.

    5. Install knuckle on lower arm. Tighten castle nut (50 to 60 N-m or 36 to 43 lb-ft) and install a new cotter pin. Torque the castle nut to the lower torque specification; then, tighten it only far enough to align slot with pin hole. Do not align nut by loosening.

    6. Tighten new spindle nut (185 N-m or 134 lb-ft). After tightening, use a drift to stake spindle nut shoulder against driveshaft.

    7. Install front wheels (110 N-m or 80 lb-ft).

    8. Tighten damper pinch bolt and new damper fork nut. Tighten damper pinch bolt to 44 N-m or 32 lb-ft. Tighten damper fork nut to 65 N-m or 47 lb-ft.

    9. Refill transaxle, if necessary, with recommended fluid.

    10. Check front wheel alighment and adjust, if necessary.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

94 honda civic ex [ 6 Answers ]

Well I have an 94 civic ex and it's giving me problems and the problem is that when I shift gear and go (happens on every gear) then its making this sound from the engin and plus the car is'nt picking up speed like not enough airflow going though or burning gas so I think my trans bad or clucth is...

Honda civic si [ 2 Answers ]

What is the engine of a 1990 civic si

98 Honda Civic [ 1 Answers ]

My Heating system doesn't work at all... nothing lights up in the heating instrument... what could the problem be?? If it is the heater really where would that relay be? Also I just bought the vehicle could it be that the heater instrument isn't connected since nothing lights up?

84 Honda Civic [ 2 Answers ]

Wondering if you have to take the half shaft out to get the alternator out. Doesn't look like thers is a whole lot of room to pull the alternator out. Thanks

91 honda civic [ 1 Answers ]

When I start my car it makes a loud and constant grinding noise it recently had the oil drained and was sitting without oil for about two weeks?

View more questions Search