Ask Experts Questions for FREE Help !
Ask
    lou21963's Avatar
    lou21963 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 17, 2008, 07:27 PM
    92 camry won't engage the starter
    My 92 camry when trying to start only dims the radio and clock. The starter was removed and with it disconnected still dimmed the radio and clock. I had the starter checked out and its perfect. I also changed the battery and positive battery terminal. I tryied also to start it in neutral, no luck. Any help out there?
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
    		  
    #2

    Jan 18, 2008, 06:23 AM
    Does the engine turn over, or nothing at all?
    Check all the fuses, particularly the ST Main fuse underhood. If they are good, check for battery voltage on the small wire connected to the starter while the key is in the start position. You could still have an open in the neutral safety circuit on the control side of the starter relay.
    BTW: both the radio and clock displays will go dim during starting. That is normal.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Johne Deere L110 - Starter spins but does not engage [ 6 Answers ]

Hi, I have a John Deere L110 (almost 3 yrs). After sitting idle most of the winter, I went to start it up and got nothing. Re-charged the battery and now I get the starter motor spinning very fast ("whirring" sound), but it does not seem to engage the flywheel. I see from some other posts on...

2001 Honda Civic - Starter - Can you show me the location of the starter? [ 3 Answers ]

I'm having starting problems with my 2001 Honda Civic EX 4DR. This is the first problem with the car and I can't find the starter. Can you help?

John Deere Lawn Tractor Starter Won't Engage [ 2 Answers ]

Always get a "click" when I try to start JD lawn tractor, but the starter won't actually engage now to turn the motor over. The lawn tractor is an older model 185 - 14 hp Kawasaki engine. Any suggestions? Thank you for your assistance. Jack

Heater will not engage [ 2 Answers ]

We have a 12 year old Saverstat electronic thermostat made by Maple Chase. It was working fine. Now the furnace is not responding to the settings either in progam or manual mode. However, if I flip the separate switch just for the blower to be on, that works. I have replaced batteries, checked...

Blades won't engage [ 1 Answers ]

I have a Rally, made for Craftsman, model 18544B, 18.5 HP Briggs, 42 inch cut. I am told it was made byAYP. Blades have stopped engaging. I have replaced the PTO switch. Following the wires some lead to a plug in into the mower that is in the base of the frame on the right side, just above the...

View more questions Search