Heater burners will not stay lit

skyvinnie Posts: 2, Reputation: 1

New Member

Dec 13, 2007, 10:53 AM

Heater burners will not stay lit

The burners on my heating unit ignite, but go out once the electronic ignitor turns off

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Dec 13, 2007, 01:01 PM

Model number and brand?

Add your answer here.

Check out some similar questions!

Burners do not stay lit. [ 3 Answers ]

Burners do not stay lit. I have a brand new Goodman GPG13 package unit with a 138,000 BTU natural gas furnace. The furnace has six (6) burners and an electronic spark ignition. All burners light, then (after about one (1) minute) the bottom burner or bottom two burners sputter or just go out may...

Why will my burners not stay lit [ 1 Answers ]

My forced air furnace does not stay lit when the heat is turned on. I climbed into the attic where it is located and had my wife set the thermostat to heat. I observed the burners light and watched the Honeywell limit switch start to do it's thing but after about a minute the limit switch...

Bryant-burners won't stay on. [ 1 Answers ]

I have a Bryant Model 397H. Have had an intermitent problem for the past 3 years. Furnace starts normally, burners come on and in about 5 seconds go off. This can repeat two to three times before remaining on and running normally. I have had two repairmen out to look at it and both times it would...

Burners won't stay lit! [ 2 Answers ]

Please help. My furnace will come on when it is supposed to, glow plug will glow, then after a few seconds the burners will come on, but they will not stay on. They fire up for about five seconds then shout down. This will cycle a couple of time then the furnace then just totally quits. Ant ideas? ...

Burners won't stay lit [ 2 Answers ]

-- need more help in figuring out flame sensor or roll out switch - Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)---burners light for 1 or 2 seconds, then go out