Ask Experts Questions for FREE Help !
Ask
    pick's Avatar
    pick Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 9, 2007, 05:37 PM
    Furance cut in / out too much
    I have a bryant furance, we moved in a couple of weeks now. The furanace cycles in and out too much, from start up to shut down it last 9mins. Any Ideas what it might be. Thanks.
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #2

    Dec 9, 2007, 05:45 PM
    If you have a mechanical thermostat , then you might need to adjust the heat anticipator in the thermostat, there is a arrow pointing to numbers on a bar , move to 4.5 and see if that dose it. Good luck, Mike
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furance not turning on with auto [ 1 Answers ]

When I set the tempture up to 80 degrees on the thermometer and turn to auto the heat does not switch on? Our pilot light is lite and when I turn the heat on it only cool air comes out. Any ideas? Thanks for the help!

Furance won't stay on [ 1 Answers ]

My furance turns on for about30 seconds then turns off for about 3 seconds never long enough for blower to come on

Oil furance [ 2 Answers ]

My oil furance won't light it is a beckett afg model how can I light

Humidifier and Furance Hookup [ 1 Answers ]

I have a pair of Carrier 100 BTU furnaces controlled by a Honeywell programmable thermostat. There is a Aprilaire humidifier with a completely separate control attached to the furnace. I purchased a fan relay Steveco 90-293Q to wire the humidifer inline with the furnace thermostat control. I would...

View more questions Search