Ask Experts Questions for FREE Help !
Ask
    agrace01's Avatar
    agrace01 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 20, 2007, 07:37 AM
    Furnace burner
    Greetings,I have a tempstar furnace model ntc6075fba1,s/n l984128725, the pilot lights, then the blower comes on but the burner does not come on, then when the thermostat is turned down the blower continues to run.please inform me of the problem.Thank you, Albert.
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #2

    Nov 20, 2007, 08:05 PM
    It sounds like you are having trouble at the gas valve. Check with a volt meter to see if you are getting 24 volts to the gas valve. If you are then I think the valve is bad. If you are not getting voltage to the valve then it could be the limit or fan switch. Or it could be different things depending on what kind of pilot system you have.
    agrace01's Avatar
    agrace01 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 20, 2007, 09:23 PM
    Quote Originally Posted by letmetellu
    It sounds like you are having trouble at the gas valve. Check with a volt meter to see if you are getting 24 volts to the gas valve. If you are then I think the valve is bad. If you are not getting voltage to the valve then it could be the limit or fan switch. Or it could be different things depending on what kind of pilot system you have.
    Thanks, I will check the things you mentioned, really appreciate the help. Albert
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace burner does not stay long and goes out [ 3 Answers ]

My furnace burner does not stay long. I had my pilot light goes out. I lit the pilot light and it works. And as soon as I put the wall thermostat on ON position for heat, I can see the burner starts with the normal flame. But after 30 seconds burner flame goes off as well the pilot light goes out...

Furnace Burner Won't Light! [ 3 Answers ]

I have a Lennox Whisperheat gas furnace model no. G20Q3/4E-125-2. On normal start up the pilot would light and then there would be a click click click noise several times then the burner would light and the blower would kick on. Now what is happening is the pilot lights and then the clicking...

Bryant Furnace Burner Going On and Off [ 1 Answers ]

Bryant Gas Furnace P/N 394DAC03100 about 30 yrs old. Pilot light stays light and burner going on and off after checking valve problem seems to be some type limit switch when I move the wiring by shaking a little it ignites. Having a problem finding which wires are loosely connected..? If anyone...

Oil furnace, Burner cuts out [ 4 Answers ]

Ok, my original post was over a noisy draft regulator. Since then I have determined the cause of the regulator banging was the burner going out. This only occurs for a fraction of a second, just little pulses. I changed my in-line fuel filter and my burner nozzle. When I remove the inspection cover...

Oil Burner Furnace [ 1 Answers ]

The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is...

View more questions Search